How to install the high accuracy clock option on an SSG5000X RF Signal Source

October 6, 2020

NOTE: The use of an anti-static mat and gloves are recommended.

  1. Remove the two screws from the OCXO cover located on the rear panel of the SSG5X:

 

  1. Insert the clock source with the “can side down” as shown and press into the mating connector. The surface should be flush or slightly below the rear panel.

  1. Replace the OCXO cover and tighten the screws.

  1. Power on the unit, press UTILITY > Options to view the enabled option: