In this video, Thomas Rottach from SIGLENT EU presents information on overcoming common power supply design issues through different testing methods. The first presentation of this material was at the Power Electronics Forum @ virtual Electronica 2020.
In this video, we use the Search and Navigate feature of the SIGLENT SDS2X Plus scope to isolate and indicate low voltage conditions of an input signal. Here, we use an SDG signal generator to produce a 60 Hz sine wave and we introduce a few periods of much lower voltage.. simulating dirty power/brownout conditions … Continued
In this video, I compare the response from two power supplies using a stepped load to show the differences between a well-tuned supply and one that exhibits excessive ringing. Also, add in some basic instrument requirements to help get you started making your own step load tests. Here, I use a SIGLENT SDL1X-E DC Electronic … Continued
In this video, we show how to use the automated Bode Plot feature of the SIGLENT SDS1004X-E series of four-channel oscilloscopes to create a frequency response curve. This function also applies to the following oscilloscope and generator series: SDS2000X-E SDS2000 X Plus SDS2000X HD SDS5000X SDS6000A SDG1000X SDG2000X SDG6000X SDG7000A SAG1021 SAG1021i There is … Continued
Siglent Founder and CEO Eric Qin visited the EEVblog Lab and very kindly agreed to sit down for a quick impromptu chat. NOTE: Proper English subtitles are available. http://siglent.com/ens/ Forum: http://www.eevblog.com/forum/blog/eev… EEVblog Main Web Site: http://www.eevblog.com The 2nd EEVblog Channel: http://www.youtube.com/EEVblog2
Learn how to use the dropout trigger to isolate signals that are below a set trigger value and are missing information.
In this video, we show how to characterize a filter using a scope and function generator. We also compare the scope/gen data to the same filter tested using a spectrum analyzer and tracking generator.