SDS1000X-E New Fixed Position Zoom
February 8, 2018
This feature allows the user to adjust the position selections for horizontal and vertical zooming. Traditionally, most scopes allow you to zoom around a fixed position. This is typically the center of the display (which is the standard operation on all SIGLENT scopes). We refer to this as fixed delay for horizontal and fixed offset … Continued
Standard probe product list
December 27, 2017
Here is a list of probes currently supplied with each oscilloscope: Click here to view the Product Probe List
Waveform Capture and Regeneration using EasyWave Software and a SIGLENT oscilloscope with the AWG option
December 27, 2017
Some SIGLENT oscilloscopes feature an Arbitrary Waveform Generator (AWG) option. This feature allows you to source basic waveforms up-to 25 MHz outputs up to 6 Vpp (-3 to +3 V max in High Z output impedance). In this application note, we are going to show the steps involved in capturing a waveform on a SIGLENT … Continued
How to Capture a Runt Pulse with a SIGLENT SDS Oscilloscope
December 27, 2017
Capturing a Runt Pulse The new Super Phosphor Oscilloscope (SPO) technology supports deep memory, a fast waveform refresh rate and a 256 grey scale and color temperature waveform display. The intelligent Pass / Fail function is widely used in industrial electronic detection. The technology also includes powerful intelligent triggering (window, interval, timeout, pattern, Runt). Here … Continued
How to save to an external USB with the SDS series of oscilloscopes
December 22, 2017
The SDS series of SIGLENT Digital Oscilloscopes have a number of save options that include copies of the displayed image (Bitmap, JPG, and PNG are common image types) as well as instrument configurations (Setups) and data (CSV). Here are brief instructions on how to save files to external USB memory devices. Insert a USB memory … Continued
What instruments accept SCPI commands for remote control?
October 25, 2017
All SIGLENT instruments (except for the SHS1000 and SHS800 hand-held oscilloscopes) support SCPI remote control commands. For more information, download the specific instrument programming guide located on the product page.
SDS1000X-E Low Frequency FFT Performance
October 25, 2017
One of the more exciting features of the SIGLENT SDS1000X-E Series of Oscilloscopes is the 1 Mpoint FFT capability. Coupled with the 500 uV/div low voltage measurement range and the fast waveform update rate, this feature makes the SDS1000X-E a powerful spectrum monitoring tool. In this tip, we show you some screenshots of the FFT … Continued
SIGLENT X and X-E series oscilloscopes Sequence and History mode
October 25, 2017
With the advance of science and technology, more demands are being placed upon stability, performance, and the intelligence of electronic products. Product design engineers face many problems with the verification and debugging of high-speed signals. A typical example is intermittent glitches with some low duty cycle signals, such as laser pulses or other signals. To … Continued
Oscilloscope Hardware Reset
October 25, 2017
In some extreme hardware errors, the oscilloscope may become unresponsive or “hang” during the boot sequence. If your oscilloscope is frozen, will not boot, or appears to be unresponsive, you can attempt a hardware reset by following these instructions: 1. Disconnect all USB, LAN, and input cables. Leave the power cord connected. 2. Power cycle … Continued
Self-Calibration with the SDS Series Oscilloscopes
October 25, 2017
Over time and temperature, the components in a test instrument can change and adversely alter the performance and measurement accuracy. Periodically running the self-calibration routine can help ensure top performance. You can run the self-calibration routine at any time, but it is recommended if the operating temperature changes by more than 5 °C. 1. Disconnect … Continued